Disabling the Reverse Rev Limiter

So far I haven't done this, but I took it from another site. If someone trys this before I replace this message with "I did it and it works" send me an email and I will change it.

1) Disconnect the battery

2) Disconnect the black wire with the red trace and the blue wire with the black trace and put a piece of heat shrink tubing over each one of them and put a dab of silicone in the hole the wires came out of.

3)Pull out the black wire with the brown trace and the black wire with the white trace. Keep track of the hole they came out of. Make a small jumper wire (approx. 28 ga.) about 2" long. Slide it  under the rubber seal on the black/brown wire connector pin and solder it to the pin. Do the same with the other end of the jumper wire and solder it to the black/white wire connector pin. Now put these two pins back in there respective holes. Put a dab of silicon between the jumper wire and the wire it is next to.

JonnhyCat says this works:

"I cut the black w red tracer wire and sealed them off on mine it works fine for me"